Ellis-Lubec 28 – SOLD

This slideshow requires JavaScript.

2001 Ellis-Lubec 28 Lobsteryacht
LOA 28′ 4″ BEAM 9’4″ DRAFT 3′
SOLD

This is a one of a kind Ellis-Lubec 28. Hull Design by Ralph Ellis. She was built in 2001, when Ellis Boat Company and Lubec Shipyard had established a partnership building the classic Ellis 28. This fine 28′ Lobsteryacht includes a Yanmar diesel, bow thruster, Stidd helm seat, electric windlass, generous seating inside or out, an enclosed head, and all the required electronics for cruising.

Engines: Yanmar 315 HP – 6LPASTP
Cruising Speed: 15-20 knots
Maximum Speed: 22-26 knots
Engine Hours: 519

ACCOMMODATIONS
2 berths forward
Enclosed head with sink & shower
Galley with stainless steel sink & counter
Refrigerator
Origo 2 burner stove
Cabinet storage
Opening hatches and ports with screens

SHELTER
Steering station with S/S wheel & instrument panels
Folding table
3 opening windshields
Electric wipers
Opening side and aft windows
Helm chairs; 1 x Stidd; 1 x Todd
Adequate space for additional seating
Hydraulic assisted hatch for engine access

COCKPIT
Generous ( 6′ x 8′) open area for fishing or additional seating
Rod holders
Tow bit
Flag holder
Storage bins
Teak swim platform full beam width

INCLUDED ONBOARD
Bow thruster
Racor fuel filter
Stainless steel wheel with hydraulic steering
5 Blade prop
Evolution drive system
Soundown muffler
Spurs
Lewmar electric windlass
Electric horn
110 volt shore power system with battery charger
Electric water heater
Bus heater
Northstar 952X chartplotter
Furuno 1622 radar
Icom VHF
Simrad AP 16 autopilot
Inverter
B & G Network Quad depth and speed
Three opening windshields
Opening side windows and aft curtains
Bomar hatch with screen
Large cockpit
Full canvas enclosure of pilot house
Teak handrails on house tops and alongside
Teak bowsprit with anchor roller
CQR anchor
Battery charger
Teak swim platform
2 Folding deck chairs
Guest remote control spotlight
4” Compass
Stainless opening ports and hatch
Holding tank with macerator
Fresh water tank
Fenders, docklines, water hose
Pressure water system
Spare parts & lines

GENERAL CONSTRUCTION
Solid hand laid fiberglass hull with four 2″ X 6″ full length stringers. Molded deck, cabin and shelter. Glass platform with step from cockpit to shelter. Shelter area is 7′ 6″ L X 7′ 3″ wide. Open cockpit is 6′ X 8′ with stern seat, 18″ stern deck, 8″ side decks, PVC guard and toe rails. Bronze hardware. Exterior teak. Green gelcoat hull with single boot stripe.

Specifications may vary.  Information believed to be correct, but not guaranteed.  Listings are subject to prior sale, price changes or withdrawal.