Ellis 28 Lobsteryacht SOLD

SOLD

This slideshow requires JavaScript.

2007 Ellis 28 Lobsteryacht
LOA 28’ 4”  BEAM 9’ 4”  DRAFT 3’  DISP. = 8000lbs.

SPECIFICATIONS 

HULL:

  • Semi-displacement hull w/ integral fiberglass skeg protecting shaft, propeller & rudder
  • ISO NPG gelcoat with vinylester resin
  • High-tech composite with stitched biaxial E-Glass construction for superior strength
  • Stitched biaxial structural E-Glass reinforced stringer system
  • Gelcoat finished bilges for ease of maintenance
  • Painted boot stripe
  • Unepoxy antifouling bottom paint under contrasting ablative bottom paint
  • PVC Spray Rails (white)

DECK:

  • ISO NPG gelcoat with vinylester resin
  • High-tech composite with stitched biaxial E-Glass construction for superior strength
  • Vacuum bagged ATC Core-Cell® structural foam core construction
  • Custom gelcoat finished non-skid surface

ENGINE SYSTEM:

  • Fresh water-cooled 260-hp Yanmar diesel engine
  • 80-amp, 12-volt alternator
  • ZF63A marine transmission
  • 1½” stainless steel shaft system
  • 18” 4-blade magnesium-bronze propeller
  • Wet exhaust system
  • Groco 1½” raw water intake strainer
  • White gelcoat finished engine room
  • 2″ Soundown™ sound insulation on main bulkhead, under all floor panels & hatches
  • All access hatches lined with acoustical gasketing
  • Engine compartment cooling through side-mounted, molded fiberglass, dorads
  • Ball valve style silicon bronze seacocks with double hose clamps on all hoses

FUEL SYSTEM:

  • (1) ABYC, NMMA & USCG approved 80-gallon baffled aluminum fuel tank
  • 500 Series Racor 30-micron primary fuel filter/water separator
  • Yanmar 2-micron secondary fuel filter/water separator
  • (1) stainless steel diesel deck fill
  • USCG approved, fire resistant fuel hoses

STEERING SYSTEM:

  • 15” stainless steel destroyer wheel
  • Hy-Nautic Hydraulic steering
  • 316 stainless steel rudder (1½” diameter rudder post)

FORWARD CABIN:

  • V-berth with Sunbrella® covered cushions
  • Drop-in storage compartments under V-berth cushions
  • Chain locker forward
  • Fiberglass floor with custom gelcoat finished non-skid surface
  • (4) Lewmar opening port lights
  • (1) Bomar hatch

GALLEY:

  • Molded fiberglass counter with teak fiddle rail and trim
  • Stainless steel sink
  • Teak drawers and storage lockers doors below counter
  • Fresh water system

HEAD:

  • Molded fiberglass enclosure with teak door
  • Sealand Sani Potti

SHELTER:

  • Teak companionway doors and cover
  • (1) engine box
  • (2) engine room hatches with gas struts, stainless steel compression latches and hinges
  • Pedestal helm/nav seats
  • (3) powder coated aluminum opening front windows
  • (2) powder coated aluminum fixed side windows
  • Fiberglass floor with custom gelcoat finished non-skid surface
  • Exterior painted side stripe matching hull color
  • Sunbrella enclosure

HELM STATION:

  • Throttle and shift control
  • Ritchie DNB 200 compass
  • Raymarine C80 chart plotter with radar
  • Garmin 3710 10″ GPS chart plotter & sounder
  • Simrad Auto Pilot
  • iCOM iC-iM304 VHF Radio
  • Engine control panel:
    • Start/Stop control
    • Tachometer w/hour meter
    • Engine temperature
    • Engine oil pressure
    • Voltmeter
    • Water temp and oil pressure alarm

COCKPIT:

  • (1) lazaret hatch with gas struts, stainless steel compression latches and hinges
  • Fiberglass floor with custom gelcoat finished non-skid surface
  • Fresh and Salt water wash down

HARDWARE:

  • (2) handrails on cabin top
  • (2) handrails on shelter top
  • (2) 6” 316 stainless steel skene bow chocks
  • (4) 8” 316 stainless steel cleats (2 amidships, 2 aft)
  • (1) Bow bitt
  • High impact PVC guards and rails (white)
  • Swim Platform
  • 4 rod holders
  • 300′ 1/2″ Rode & high tensile Danforth Anchor

12-VOLT DC ELECTRICAL SYSTEM:

  • 2) Group 27 engine start batteries in boxes
  • 2) Group 27 house batteries in boxes
  • Guest 10 amp battery charger
  • Heavy-duty battery switch
  • DC circuit breaker panel
  • USCG approved running and masthead lights
  • (1) ¾” 800 GPH automatic 12-volt electric bilge pump

LIGHTING:

  • 5½” stainless steel dome lights (2) over V-berth, (1) in galley, (1) in head, (1) above companionway (includes red lens to preserve night vision) 

FINISH:

  • All interior and exterior teak finished with teak oil
  • Shelter, Cockpit, and Main Bulkhead – Fared “smooth” finish

Specifications may vary.  Information believed to be correct, but not guaranteed.  Listings are subject to prior sale, price changes or withdrawal.